Table of Contents
Advertisement
9. Take the loose label stock and feed it between the liner idler roller and the liner drive roller.
In order to feed the label stock between the rollers, the liner idler roller should be in the
unclamped position.
Note: This procedure assumes that the first 12 inches [30 cm] of labels will not be
applied to the container using the Applicator. Of course, you may still apply these
labels by hand.
10. Pull the label stock all the way through until the end of the roll is laying over the top of the
label stock roll. Adjust the label stock forward or backward so that the peel edge is between
two labels.
Page | 14
Advertisement
Table of Contents
