Primera AP380 User Manual page 33

Swapping theLabel/Container Guide Positions to Accommodate Narrower Labels
You can swap the positions of the container guides or the label guides to allow the guides to
be moved closer together to accomodate shorter containers or narrower labels.
Label Guide Instructions
1. Loosen one of the thumbscrews until it is removed. Hold your hand underneath the guide
plate to catch the nut as it falls.
2. Move the label guide to the other side of the other label guide and place it back onto the
guide plate with the location tab in the slot.
3. Place the nut on the underside
of the guide plate so that the
locator tab is closest to the
locator tab on the label guide.
4. Insert the thumbscrew and turn
clockwise until it is tight.
Container Guide Instructions
1. Move one of the container
guides to the far outside of its
travel. Loosen the thumbscrew
until it is removed. Hold your
hand underneath the guide
plate to catch the nut as it falls.
Access to the underside is only
available at either end of the
guide plate.
2. Move the remaining container guide to the other side of of the other container guide and
place it back onto the guide plate with the locator tab in the slot.
3. Place the nut on the underside of the guide plate so that the locator tab is closest to the
locator tab on the label guide.
4. Insert the thumbscrew and turn clockwise until it is tight.
Clean Label Gap Sensor Flag
Over time adhesive from the labels can build up on the sensor flag just above the container
rollers. Periodically clean the top of the sensor flag with a Q-tip and alcohol.
Page | 33
KnowledgeBase Article
Label Guide