Table of Contents
Advertisement
US/CA
5.5
Selecting and adapting DHW program
At the factory, a DHW program is set that suits
most cases. The DHW program consists of:
a program for hot water heating
•
a program for a recirculation pump
•
Factory settings of the program for DHW heating
Day
Program points
P1
°F / On/Off
Monday –
140 °F (60 °C)
2)
Friday
/ On
140 °F (60 °C)
Saturday
2)
/ On
140 °F (60 °C)
Sunday
2)
/ On
Tab. 6
Factory settings of the program for DHW heating
1) DHW heating with DHW tank
2) DHW heating with combi boiler
Factory settings for the program for recirculation pump
Day
Program points
P1
On/Off
Monday –
ON
Friday
Saturday
ON
Sunday
ON
Tab. 7
Factory settings of the program for recirculation pump (the program for recirculation pump is
only available for hot water heating with DHW tank)
P2
Switch
point
°F / On/Off
1)
60 °F (15 °C)
05:00am
/ Off
1)
60 °F (15 °C)
06:00am
/ Off
1)
60 °F (15 °C)
07:00am
/ Off
P2
Switch
point
On/Off
06:00am
OFF
07:00am
OFF
08:00am
OFF
Both programs are already matched to one
another and activated.
This section shows you how you can either
deactivate the programs and connect them with
the active heating programs or adapt them
individually.
Switch
point
1)
11:00pm
2)
1)
11:00pm
2)
1)
11:00pm
2)
Switch
point
11:00pm
11:00pm
11:00pm
Operation with open flap | 21
P3 to P6
°F / On/Off
–
–
–
P3 to P6
On/Off
–
–
–
6 720 643 262 (2010/05)
Switch
point
–
–
–
Switch
point
–
–
–
Advertisement
Table of Contents
