Advertisement
Connecting the SMC serial cable
The SMC chiller cable needs an adapter to plug into the back of the chiller.
1. Plug the adapter (P/N:001-115197-XX) into the back of the chiller.
2. Plug the chiller cable (P/N: 001-112405-XX) into the adapter on the back of the chiller.
3. Plug the other end of the chiller cable into the projector.
If the projector is turned on when you connect the cable, the projector display shows
a disconnected error message. When you navigate through the prompts to get to the
communication, the message disappears.
Navigating to the Communications menu
Follow these steps to navigate to the Communications menu.
The initial display shows the coolant temperature and setpoint.
PV
SV
1. From the coolant temperature and setpoint on the display, select and hold the Menu button,
releasing the button when the chiller beeps (after approximately two seconds).
2. Select and hold the Menu button three more times to navigate through the menus to get to
the Communication menu.
Installing the SMC HRS-040 Chiller Instruction Sheet
020-103867-02 Rev. 1 (01-2024)
Copyright
©
2024 Christie Digital Systems USA, Inc. All rights reserved.
If printed, please recycle this document after use.
Installing and setting up the SMC HRS-040 chiller
8
Advertisement
