Advertisement
B B
A A
5. Install the sub-assembly to the chiller outlet, making sure the assembly is facing down.
6. Remove the plastic cap from the chiller return port.
7. Apply three to four rounds of grey sealant tape to the following components:
•
½" NPT male-to-female 90° elbow (B in the image in step 9)
•
Female (socket) quick disconnect (A in the image in step 9)
•
½" NPT-to-½" PT adapter (can be found in the particle filter packaging; C in the image in
step 9)
Installing the SMC HRS-040 Chiller Instruction Sheet
020-103867-02 Rev. 1 (01-2024)
Copyright
©
2024 Christie Digital Systems USA, Inc. All rights reserved.
If printed, please recycle this document after use.
Installing and setting up the SMC HRS-040 chiller
C C
4
Advertisement
