German pool EFB-326H-SC User Manual page 12

Operating Instructions
Warm Mode Instructions
1. Press Warm Mode Button and the display shows the ambient temperature.
2. Press the "+ / -" on the right side to set the temperature, and the digital display will blink, which
temperature can be set from 1-30°C.
3. 10 seconds after the desired temperature is set, the blinking will stop.
4. The temperature being set should be higher than the ambient temperature, so that the heating
function will be turned on.
5. When the ambient temperature reaches the set temperature, the heating function will stop and
turn into a cool breeze.
6. When ambient temperature drops to below the set temperature, the heating function will
automatically be activated.
Set
Ambient
Temperature
Temperature
25°C
18°C
Note:
The default temperature of the setting is 25 °C.
In Warm Mode, when the ambient temperature is below 0°C, the display only shows 01, does not
display negative temperature value.
When Warm Mode has been activated for over 9 hours, the product will automatically stop running.
Restart by pressing On/Off Button on the main unit or by using the Remote Control.
Note:
Please use Remote Control to set temperature; On/Off Button on the main unit does not support this
operation.
Set Temperature > Ambient Temperature: heating function turns on.
Set Temperature ≤ Ambient Temperature: heating function stops.
P.12