Table of Contents
Advertisement
Modifying the Sound in Real Time (DSP Filter)
Modulating in Sync with the BPM (MODULATOR 1 Block)
Procedure
1.
Use [CH SELECT] to select the channel to which you wish to apply the
effect.
e
Use [FREQ RANGE] to select the frequency range at which you wish to
apply the effect.
e — Specify the FILTER Block (P.14)
2
4.
се [LFO WAVE] to select the waveform.
5.
5еі [SYNC TYPE] to select the beat (note value).
6
•
Turn [ГЕО DEPTH] їо adjust the effect.
1
45
6
3
FILTER
2
LFO WAVE
:
:
Triangle Wave
Select the shape of the wave (LFO waveform) that will
modulate the sound.
Press the button to cycle through the available selections
for the waveform: Triangle, Sawtooth, Reversed Sawtooth,
and Square.
By holding down [ТАР (SHIFT)] while you do this, you сап
PSI
Reversed Sawtooth Wave
Sawtooth Wave
cycle through the waveform selections in reverse order.
Square Wave
SYNC TYPE
Select the rate at which the sound will be modulated, in beats (note value). The beats are based on
the BPM setting.
If [SYNC TYPE] is in the OFF position, the LFO WAVE and LFO DEPTH settings will
be ignored. Use this setting when you wish to Turn [CUTOFF] manually to modify the
effect.
LFO DEPTH
Specify the depth of the modulation that will created by the waveform selected in [LFO WAVE].
Increasing this value (turning the knob clockwise) will produce deeper modulation.
15
Advertisement
Table of Contents
