Before using this unit, carefully read "IMPORTANT SAFETY INSTRUCTIONS" (Inside front cover), "USING THE UNIT SAFELY" (p. 2), and "IMPORTANT NOTES" (p. 4).
After reading, keep the document(s) where it will be available for immediate reference.
To completely turn off power to the unit, pull out Roland Service Center, or an authorized Roland distributor, as listed on the the plug from the outlet Use only the supplied power cord “Information”...
Page 3
USING THE UNIT SAFELY CAUTION CAUTION Handle the ground terminal carefully When disconnecting the power cord, grasp it by the plug If you remove the screw from the ground terminal, be sure to replace it; don’t leave To prevent conductor damage, always it lying around where it could accidentally grasp the power cord by its plug when be swallowed by small children.
• Roland is either registered trademark or trademark may cause this unit to malfunction or may produce • Depending on the material and temperature of the of Roland Corporation in the United States and/or audible noise.
Innovative DVS Mode for DVS users The DJ-99’s DVS Mode makes DJ’s life easier switching between traditional turntable setup and DVS setup. At the rear of the DJ-99, the extra pairs of DVS SEND/RETURN RCA connectors allow you to connect to your DVS audio interface. Just switch to the DVS channel on the top panel, no need to reconnect any cables and you are ready to use as a DVS setup.
Page 7
CH2. 5 If you cannot obtain a replacement fuse or if the unit still does not MASTER show the master output level work even after you replace the fuse, contact the Roland Service center. PFL/MASTER level meter...
DJ-99 through the DVS RETURN input jack. C. USING WITH THE ORIGINAL INNOFADER The DJ-99 is also compatible with the original innoFADER as below table. For more information on innoFADER, please visit Audio Innovate website. http://www.innofader.com/...
Need help?
Do you have a question about the DJ-99 and is the answer not in the manual?
Questions and answers