Roland DJ-1000 Owner's Manual page 13

Professional dj mixer
Table of Contents

Advertisement

6.
HEM
7.
8.
9.
Modifying the Sound in Real Time (DSP Filter)
GRAB Switch
This is the filter on/off switch. If this is ON, the filter will always be on. When the switch is moved
to the GRAB position, the filter will be on only while the switch is held in this position.
The waveform being synchronized to BPM will start at the moment the GRAB switch is
ON or moved to the GRAB position.
If you hold down [TAP(SHIFT)] and move this switch to ON or the GRAB position,
you can continue without resetting the waveform.
BPM Display
This shows the current BPM (tempo). (p. 20)
The decimal point will blink to indicate the beat.
The fractional portion of the BPM value is not displayed. However, the setting can be made to a
precision of one decimal place. For details on viewing and setting fractional values, refer to p. 21.
BPM ADJ v, A Buttons
These buttons allow you to set the BPM (tempo). (p. 20,21,22)
TAP Pad
You can set the BPM (tempo) to the same timing you use to tap this pad. (p. 20)
This pad also functions as the SHIFT button when carrying out the following types of settings:
Switching the [FREQ RANGE] in the reverse order (p. 12)
Starting without resetting the waveform when turning GRAB on (See the above note.)
Switching the [LFO WAVE] in the reverse order (p. 15)
Setting MODULATOR 2 to AMP mode (p. 16)
Setting the BPM in 0.1 units (p. 21)
Fine adjusting the playback timing of a MIDI device (p. 21)
Synchronizing the Start of a MIDI device to quarter-notes (p. 23)
ТО.
мо CONTROL Button
This button is used to start/stop an external MIDI device. (p. 23)
11.
EFFECT BAL (Effect Balance) Knob
uet
This knob adjusts the balance between the direct signal (unfiltered sound) and effect signal
(filtered sound) of the channel selected by CH SELECT (channel select). When it is turned fully
counterclockwise, only the direct signal will be output. When it is turned fully clockwise, only the
effect signal will be output.
The [FREQ RANGE]
(frequency range) setting does not affect the direct signal.
13

Advertisement

Table of Contents
loading

Table of Contents