operation by removing the sealing screw on the side
of the case. If no grease can be seen on the flanks
of the gear, follow the steps below to fill with gear
grease up to 3/4 capacity. Do not completely fill the
transmission gears.
1. Hold the line trimmer on its side so that the sealing
screw is facing upwards .
2. Use the multi-function wrench provided to loosen and
remove the sealing screw.
3. Use a grease syringe (not included) to inject some
grease into the screw hole; do not exceed 3/4
capacity.
4. Tighten the sealing screw after injection.
STORING THE UNIT
◾
Remove the battery pack from the power head.
◾
Clean the tool thoroughly before storing it.
◾
If the line trimmer attachment is removed from the
power head and stored separately: Fit the end cap
on the attachment shaft to avoid dirt getting into the
coupler.
◾
Store the unit in a dry, well-ventilated area, locked-up
or up high, out of the reach of children. Do not store
the unit on or adjacent to fertilizers, gasoline, or other
chemicals.
SHARPEN THE LINE-CUTTING BLADE
WARNING: Always protect your hands by wearing
heavy gloves when performing any maintenance on
the line-cutting blade.
1. Remove the battery.
2. Remove the line-cutting blade from the guard.
3. Secure the blade in a vise.
4. Wear proper eye protection and gloves and be careful
not to cut yourself.
5. Carefully file the cutting edges of the blade with
afine-tooth file or sharpening stone, maintaining the
original cutting edge angle.
6. Replace the blade on the guard and secure it in place
with the two screws.
12
56 VOLT LITHIUM-ION LINE TRIMMER ATTACHMENT — STA1600
Protecting the environment
Do not dispose of electrical
appliances as unsorted municipal
waste, use separate collection
facilities.
Contact your local government for
information regarding the collection
systems available.
If electrical appliances are disposed
of in landfills or dumps, hazardous
substances can leak into the
groundwater and get into the food
chain,damaging your health and
well-being.
Need help?
Do you have a question about the STA1600 and is the answer not in the manual?