Power Up Setting; Setback Trigger Unit; Refrigerant Leak Sensor Setting - Hitachi PC-ARFG-E Installation & Operation Manual

SERVICE & INSTALLATION MENU

6.1.16 Power Up Setting

To expand capacity of the outdoor unit. Some unit do not support
this function.
1 Select "Power Up Setting"on the "Installation Menu" screen
and press "OK".
2 If " " or " " is pressed, the settings are selected in the
following order: "OFF" ↔ "COOL" ↔ "HEAT" ↔ "Cool + Heat"
Select the setting and press "OK" to confirm the setting.
Power Up Setting
OFF
COOL
HEAT
Cool + Heat
OK Select
3 Press " " to return to the Installation Menu.

6.1.17 Setback Trigger Unit

The setback trigger unit can be set from the Installation Menu.
1 Select the indoor unit by pressing " ", " ", " ", or " " and
press "OK" to display the confirmation screen.
Setback Trigger Unit
Setback Trigger Unit selected: 00-00
00-00
00-01
00-02
OK Enter
2 Select "Yes" and press "OK" to confirm the setting. Then,
please wait a moment until the screen shows "Completed" or
"Setting Disabled".
If "Cancel" is selected, the screen returns to the Setback
Trigger Unit screen.
Set this as trigger unit:
Yes
OK Confirm
68 PMML0565 rev.0 - 09/2021
Back
Back
00-00
Cancel
Back

6.1.18 Refrigerant Leak Sensor Setting