Setback Manual Setting; Elevating Grille - Hitachi PC-ARFG-E Installation & Operation Manual

FUNCTION MENU

5.10.2 Setback manual setting

This function is used to temporarily activate Setback operation.
It is available only when Setback mode is set as Manual mode;
this function is normally used to set a long vacation.
The items cannot be set/modified if indoor unit does not support
this function.
1 Select "Setback Setting" on the "Function Menu" screen and
press "OK".
Function Menu
Power Consumption Display
Autoboost
Comfort Setting
Motion Sensor Setting
Setback Setting
OK Enter

5.11 ELEVATING GRILLE

This function is used to raise and lower grille when the air filter
and grille need to be cleaned.
It is available only when the elevating grille is equipped with the
air panel.
?
N O T E
• When the air inlet grille is set inside the air panel, ensure that the
air inlet grille is horizontal and the wire is suspended tightly without
loosening.
Wire
Gradually move Horizontal
Grille
downward
• After the above is ensured, set the air inlet grille. If the air inlet grille is
inclined and the wire is loosened, they may be caught in the pulley. It
may lead to a failure of the pulley or pulley block. If the worst happens,
it may cause personal injury if the air panel falls open.
• This function is available only for indoor unit elevating grille.
• Make sure that the unit operation is stopped before using the elevating
grille.
• The elevating grille function is not available when the unit is operating.
25 PMML0565 rev.0 - 09/2021
2 Press " " or " " to select "ON". Press "OK"and the screen
returns to the "Function Menu" screen.
• The indicator
• The indicator
(Mon) 16:30
OK Select
?
N O T E
Setback operation cannot be ON/OFF while wired controller operation is
prohibited.
Back
Set the elevating grille
1 Select "Elevating Grille" on the "Function Menu" screen and
press "OK".
• If there is only one indoor unit, the elevating grille operation
screen in Step3 is displayed.
Wire should be
vertical
Enter
OK
2 Press " ", " ", " ", or " " to select the indoor unit of which
indoor unit grille needs to be raised or lowered. Press "OK".
01-01
01-02
01-03
01-04
OK Enter
Refrigerant System No. – Address No.
turns on when schedule operation is ON.
turns off when schedule operation is OFF.
Setback Setting
OFF
ON
Function Menu
Elevating Grille
Reset Filter Reminder Time
Filter Cleaning
FrostWash Setting
Individual Louver Setting
Elevating Grille
ALL
Back
(Mon) 16:30
Back
UPDW
Back