Motion Sensor Selection; Absent Setting Selection - Hitachi PC-ARFG-E Installation & Operation Manual

FUNCTION MENU

5.9.1 Motion sensor selection

1 Select "Motion Sensor Setting" on the "Function Menu"
screen and press "OK".
Function Menu
Power Consumption Display
Autoboost
Comfort Setting
Motion Sensor Setting
Setback Setting
OK Enter
2 Press " " or " " to select "Sensor", and then press "OK".
Motion Sensor Setting
Sensor
If absent
Check interval
Select
OK
3 Press " " or " ", the sensor changes as follows:
"All modes" ↔ "Cooling+dry" ↔ "Heat" ↔ "Disable".
Select the sensor and press "OK".
Press " " to return to the "Function Menu" screen.
Sensor
All modes
Cooling+Dry
Heating
Disable
OK Select
• Disable: The operating control function by the motion sensor
is not activated.
• Heating: The operating control function by the motion sensor
is activated when HEAT mode is selected.
• Cooling+dry: The operating control function by the motion
sensor is activated when COOL + DRY mode is selected.
• All modes: The operating control function by the motion
sensor is activated when HEAT or COOL+DRY mode are
selected.
22 PMML0565 rev.0 - 09/2021
(Mon on) 16:30
Back
: Cooling+Dry
: Standby
: 60min
Back
Back

5.9.2 Absent setting selection

"If absent" is set for the indoor unit operation after the motion
sensor detects as absence for set time in "Check interval". The
operation can be selected from "ON", "Standby" or "OFF" on the
remote control switch.
• ON:
The operation is continued with saving the capacity after
detected as an absence.
If the human activity is detected for a period of time, the
normal operation will be performed again.
• Standby:
The operation mode is the fan operation at "Slo" speed. If the
human activity is detected for a period of time, the normal
operation will be performed again.
• OFF:
The operation is stopped by the remote control switch when
all the indoor units with motion sensor detect absence which
are connected with same remote control switch.
If the human activity is detected for a period of time by the
stoppage, the normal operation is performed again.
1 Select "Motion Sensor Setting" on the "Function Menu"
screen and press "OK".
Function Menu
Power Consumption Display
Autoboost
Comfort Setting
Motion Sensor Setting
Setback Setting
OK Enter
2 Press " " or " " to select "If absent", and then press "OK".
Motion Sensor Setting
Sensor
If absent
Check interval
OK Select
(Mon on) 16:30
Back
: Cooling+Dry
: Standby
: 60min
Back