Canon NP-1015 Service Manual page 71

4. Installing the Side Seals/Blade
1) Clean with alcohol the surface to which
the side seal is to be applied.
2) Apply the side seal to the position
shown in Figure 4-59.
Align the oblong hole in the end seal
with the oblong hole in the developing and
the edge of the seal with the inner face of
the hopper (see Figure 4-59) then press the
seal down firmly.
,Mgn these
faces
\
Figure 4-59
Figure 4-60 Cross-sectional view
Note 1:
Stick the side seals on the developer so that
the short side seal is aligned with the end
of the long side seal.
3)lnstall all parts other than the blade.
When installing the gear, however, as-
semble it as shown below.
Figure 4-6 1
4) Push the blade mount against the devel-
oper in the direction of the arrow and
tighten the two screws.
Fiugre 4-62
5) Loosen the four screws' that hold the
blade to the blade mount (note 2) and
retighten the screws.
Note 2:
Be careful not to remove the'blade from the
center alignment pin by loosening the
screws too much.
COPYfllGHT 0 IQ88 CANON INC.
CANON NP4015/1215S AEV.0 OCT. IQ88 PAINTEU IN JAPAN [IMPAIM~ AU JAPON]
4- 19