Canon NP-1015 Service Manual page 62

B. FEEDER
1. Removing the Feeder
1) Remove the drum cartridge, rear cover,
and fixing unit.
2) Unscrew the two screws holding the
front door strap, and open the front
door fully.
3) Remove the E-ring, bearing, and screw,
then remove the connector.
@ E-ring
@ Bearing
@ Connector
0 Screws
@ Feeder
Figure 4-31
4) Remove the DC controller PCB and the
main motor. (See Page 4-6.)
5) Remove the E-ring and the bearing.
6) Raise the closer to the end of the feeder
fixing assembly slightly, then slowly
remove the feeder from the front.
1,
@ Feeder
Note:
Figure 4-33
When removing the feeder, take care not to
. --.
damage the developing cylinder.
2. Removing the Feeder Belt
1) Remove the feeder from the copier.
2) Unscrew the two screws and remove
the cover.
@ E-ring @ Bearing
Figure 4-32
@
Screw
0
cover
Figure 4-34
4- 10 COPYRIGHT 0 1988 CANON IMC.
CAWON HP-1015/1215S AN.0 OCT. 1988 PAIHTEO IN JAPAN (IMPAlMf AU IAPONI