Installing The Enclosure - Origin Acoustics Director DSUB6 Series Installation Manual

colors or patterns are used. You can choose whichever color of wire you want to
be positive and negative as long as you remain consistent throughout the install.
On both your amplifier and your speaker the connectors will be identified as red
for positive and black for negative. It is very important to look carefully at the
speaker wires and be certain that the same wire that is attached to the positive
connector in the amplifier is attached to the positive connector in the speaker.

1. Installing the Enclosure

Hold the template to the joist that you
plan on attaching the subwoofer en-
Screws (6)
closure to. Drill six holes through the
marked locations on the template us-
Template
ing a 5/16" (8mm) drill bit. Face the en-
closure's rubber damping pad towards
Enclosure
the joist and secure it in place with the
supplied lag screws and washers. We
recommend that one person holds the subwoofer in place while another tightens
the screws to secure the DSUB to the joist.
5