Wiring: Separate Sub Amplifier & 2-Channel Amplifier - Origin Acoustics Director DSUB6 Series Installation Manual

6. Wiring: Separate Subwoofer Amplifier
Use the supplied terminal jumper
to connect two of the DSUB input
terminals, then connect the positive
wire from the subwoofer amplifier to
the positive input terminal and the
negative wire the remaining input
terminal. The satellite speakers will
be wired directly to the 2-channel
amplifier. This wiring method is recommended for both D50 and D30 speakers.
7. Wiring: 2-Channel Amplifier
Insert the left & right channel wires
from the receiver into the connectors
labeled "input from amplifier", making
sure that the positive wire is being
attached to the red connection and
the negative wire is being attached
to the black connection. You will also
probably want to run the wires from
the DSUB's terminals labeled "output
to speakers" at this time. A zip tie on the enclosure is provided to offer stress
release for the wires. Only use 1 pair of D50 speakers with a single 2ch amplifier.
Using up to 4 D30 speakers per channel is safe with 4 Ohm stable amplifiers.
9
Subwoofer
Amplifier
Amplifier
Amplifier