Table of Contents
Advertisement
9. Press the rubber tip of the hand pump against the open vacuum check port and pump until the on-screen
gauge needle reaches "GOOD". It takes about 2 to 3 full pumps. Screw-on the vacuum check port cap!
Hand pump pressed against vacuum check port
Note
•
If you pumped too much, use your fingertip to
move the yellow rubber one-way valve sideways
and release some air pressure. Then, pump again
until pressure is "GOOD".
•
If the gauge needle does not move when pumping,
inspect the main seal and the vacuum check port
O-ring and try again.
Pump until gauge needle reaches "GOOD"
24
Advertisement
Table of Contents
