Sealife SL081 Instruction Sheet

67-52mm Lens Adapter for SportDiver (Item SL081)
1) Overview: Attach 67mm and 52mm underwater lenses to the SeaLife SportDiver UW Smartphone Housing. The lens
adapter securely mounts to the SportDiver's lens port. Horizontal and vertical adjustment screws allows for aligning
the lens to the phone. Durable hard-anodized machined aluminum construction with 316 stainless steel hardware.
2) What's in the box:
Lens adapter with 52mm ring attached
3) Exchanging the threaded ring:
i) Remove screw
and washer [A],
and slide up the
ring [B] to remove.
4) Attaching the lens adapter to the SportDiver housing and centering the ring over the desired phone lens:
i) Loosen the silver screw
on the side of the
adapter using the 4mm
Allen wrench.
5) Alternate mounting options:
The lens adapter may be attached with the
left-right adjustment screw on top, which
allows the ring to be positioned in the lower
portion of the lens port. This may be
necessary for phones that have lenses
located towards the bottom.
7) Guarantee: SeaLife warrants the original purchaser of this product, for a period of one (1) year from the date of
purchase, that the product is free from defects in workmanship and materials. In the event the original purchaser believes
there is a defect in a product, it is recommended that the purchaser first visit www.sealife-cameras.com for product
updates and information on how to get warranty repair service. Please contact your local SeaLife dealer or the importer in
the country where the product was purchased for return information.
SeaLife (Div. of Pioneer Research), 97 Foster Road, Moorestown, NJ 08057 USA
67mm thread ring
ii) Insert the desired ring [C] into the
grooves of the lens frame. The flat side
of the ring must face down so the front
of the ring is even with the lens frame.
ii) Lift the side of the lens
frame up so the adapter
can be attached around
the SportDiver lens port.
6) Important:
i. It is recommended to align the lens adapter over the phone's WIDE lens,
which is usually the highest quality phone lens.
ii. For best results, use a wide-angle lens with optical magnification between
0.5x and 0.75x magnification, which allows closer shooting distances
while fitting the subject into the image frame. For macro lenses, use a
lens within 3x to 10x magnification. Macro lenses will allow you to get
closer to the subject while maintaining image sharpness.
iii. Some underwater lenses are not compatible with the phone's lens and
may result in focusing issues.
iv. If the lens vignettes, increase the zoom until vignette disappears.
v. The up-down screw may be attached to either side of the lens ring.
vi. The lens weight should not exceed 1.7 lbs (750g).
vii. After each dive, soak the lens in fresh water for about 20 minutes. Dry
lens with clean cotton cloth.
viii. Visit the SeaLife website for troubleshooting tips and technical updates.
4mm Allen Wrench
iii) Secure ring [D] by attaching
screw and washer [E]. Screw
[E] may be attach to the right
or left side of the lens adapter.
iii) Tighten the silver screw
using the Allen wrench to
securely attach the lens
adapter to the lens port.
www.sealife-cameras.com
Instruction Sheet
iv) Loosen the red
screws to move the
ring and center it over
the desired phone lens.
(Dec 2023)