Husqvarna EBE 500S Operator's Manual page 24

6. Apply silicone to the housing.
7. Lift the top liner in the slots on the sides (C) and
install it on the housing. Make sure that the top liner
is correctly aligned with the housing.
C
WARNING:
install the top liner. The top liner is heavy
and there is a risk of pinching.
CAUTION:
you install the top liner. There is a risk
that the top liner breaks.
8. Apply silicone to the slots in the top liner.
24
C
Be careful when you
Do not use force when
9. Install the 8 screws, the 16 washers, the 8 nuts and
the top liner cover.
To replace the front rubber seals
WARNING:
are necessary for this procedure. 1 person
replaces the front seals, and 1 person holds
the product in position.
1. Operate the product rearward up a ramp.
2. Do the steps that follow to tilt the product rearward:
a) 1 person pushes down on the handle of the
product to tilt the product rearward (A).
B
b) The second person puts a piece of wood below
the front of the product (B).
c) 1 person continues to hold the product in position
by the handle.
A minimum of 2 persons
A
2338 - 001 - 13.12.2023