Husqvarna EBE 500S Operator's Manual page 20

General product maintenance
Do a check of the brush list
seals and the front rubber seals
for wear.
Do a check of the hydraulic
connections and hoses.
Do a check of the oil level.
Make sure that the nuts and
screws are tight.
Do a check of the V-belt ten-
sion.
Do a complete servicing and
cleaning of the product.
Replace the oil return filter and
the oil suction filter.
To do a check of the hydraulic hoses
• Examine the hydraulic hoses regularly. Replace
worn or damaged hydraulic hoses.
WARNING:
The rubber in the hydraulic hoses wears with
time. Worn or damaged hydraulic hoses can
break and the hydraulic oil can cause injury.
If you cannot tell if the hydraulic hoses are
worn, always replace the hydraulic hoses.
To do a check of the hydraulic oil level
• The hydraulic oil level must be in the middle of the
glass on the oil level indicator.
• Fill the hydraulic tank if the hydraulic oil level is too
To fill the hydraulic oil on page 20 .
low. Refer to
To fill the hydraulic oil
1. Park the product on level ground.
20
Each 3 h
Hydraulic oil is dangerous.
12 h after
Daily
servicing
*
*
*
*
2. Remove the cap to the hydraulic oil tank.
3. Fill hydraulic oil in the hydraulic oil tank. Refer to
Technical data on page 29 for information about the
correct type of hydraulic oil.
4. Install the cap to the hydraulic oil tank.
5. Do a check of the hydraulic oil level. Refer to
check of the hydraulic oil level on page 20 .
To clean the product
• Always clean all the equipment after use. Use a
vacuum cleaner.
• Do not use a high-pressure washer to clean the
product.
• Keep the air openings clean and clear to make
sure that the product always has sufficiently cool
temperature.
Each 3
Yearly
months
X
O
O
To do a
2338 - 001 - 13.12.2023