Assembly Instructions - Craftsman INCREDI-PULL 316.794010 Operator's Manual

4-cycle backpack blower

Hide thumbs

Table Of Contents

Table of Contents

Available languages

ASSEMBLING THE BLOWER TUBE

WARNING:

To avoid serious personal injury and damage to the

unit, shut the unit off before removing or installing the blower tubes.

Installing the Flex Tube

Place a hose clamp over the

end of the Flex Tube (Fig. 1).

Slide the end of the Flex

Tube with the clamp on it

over the elbow tube and

tighten the screw on the

hose clamp (Fig. 1).

Installing the Upper Blower

Tube

Place a hose clamp over the

other end of the Flex Tube

(Fig. 2).

Slide the end of the hose

with the clamp on it over the

top end of the upper blower

tube and tighten the screw

on the hose clamp (Fig. 2).

Installing the Lower Blower

Tube and Nozzle

Insert the bump on the upper

blower tube into the bump

slot on the lower blower tube

(Fig. 3).

While holding the upper

blower tube, twist the lower

blower tube clockwise until it

locks into place (Fig. 3).

Insert the bump on the lower

blower tube into the bump

slot on the nozzle (Fig. 4).

While holding the lower

blower tube, twist the nozzle

clockwise until it locks into

place (Fig. 4).

The completed blower tube

should look like Figure 7.

WARNING:

To avoid

serious personal injury,

make sure that the

blower tubes are

locked in place or

firmly installed.

Secure the Throttle Cables

Place a zip tie around the elbow

tube and the throttle cables, as

shown (Fig. 5). Tighten the zip tie,

making sure not to crimp the cables.