Panasonic SC-HT790V Operating Instructions Manual page 16

Operating the television
TV/VIDEO
2
--2
I<1< TV VOL-
IHIH TV VOL+
• CHA
• CHv
• "IV maker setting
You can control the television by entering the remote control code.
1
2
Refer the chart below for the code for
your television.
Aiming the remote control at the television
While pressing and holding [TV],
press the numbered buttons to enter
the code number.
• Example: To select 01, press [0] -. [1].
eThe remote control outputs the on/off signal. If the code is
correct, the equipment bJms on or off. If it doesn't, try
entehng another code.
m
elf your television brand is not listed or if the code listed for your
television does not allow control of your television, this remote
control is not compatible with your television.
• Reenter the codes after you change the batteries.
• TV operation
Operation
Power on/
standby
Remote control
TV mode
TVfideo switch
Selecting
channels
Adjusting
volume
Bu_ons
[_]
[TV]
• Switch the remote control mode to TV. Press
before doing TV operations, When in TV
mode, the [3_] button lights each time you
press an operation button.
[TV/VlDEO]
[A CH ^] [V CH v ] or numbered buttons
[1-9, 100, 0, _10/ENTER].
• [->10/ENTER] is used to confirm channel
selection on some televisions manufactured
by other companies.
[I<P< TVVOL ][IH_ TVVOL+]
Panasonic
G.E.
HITACHI
LXl
MITSUBISHI
: EC
PHILCO
01, 02
02, 03, 07, 09
PHILIPS 06
QUASAR 02
SANYO 14
SONY 04
SYMPHONIC 17
TOSHI_ 10,21
ZENITH
'
18, 20