Panasonic SC-HT790V Operating Instructions Manual page 43

The unit
t unes automatically after you plug it in and tum it on for the first time (-, page 15, Plug-in Auto Tuning), but you can start the process
again if necessary.
oMake sure you have tuned to a television channel. This does not work if you have selected "AU" channel.
While the VCR MENU is displayed
1
Press [i, T] to select "CHANNEL SET" and press [ENTER].
I ANTENNA SYSTEM
2
Press [i, T] to select "ANTENNA
SYSTEM" and press [ENTER].
3
Press [&, Y] to select "TV" or
"CAW" to suit the type of antenna
you are using.
I MANUAL J
You can manually preset channels that are skipped when using the
auto channet setting, and manually skip channels that are preseL
2
Press [i, Y] to select"MANUAL" and
press [ENTER].
3
Press [A, V] to select "CH" and
['<, I_] to select the channel.
4
Press [A, Y] to select "BLANK" and
[<, I_] to select "ON" or "OFF".
Channels are set corresponding to the antenna system you select.
This is set automatically when you do Plug-in Auto Tuning.
To exit the settings screen
Press [MENU] until the screen disappears.
[AUTO }
Auto tuning searches for TV stations and memorizes every tuned
program position. Other program positions are skipped. (Channel
range .- right)
2
Press [i, V] to select "AUTO" and
press [ENTER].
Auto tuning starts. It takes three or more minutes to complete.
To stop partway through
Press [MENU].
To exit the settings screen
Press [MENU] until the screen disappears.
• Channel range
eTV mode
Band Airwaves
VHF 2-13
UHF 14-69
eCATV mode
Band
VHF
CATV LOW BAND
CATV MID/SUPER BAND
CATV HYPER BAND
ULTRA BAND
SPECIAL CATV CHANNEL
Cable
2-13
95-99
14-36
37-65
66-94
100-125
1
RQT6951