Extreme Networks IA-A-20 Installation Manual page 16

6 In the Configure Date and Time Settings screen, select whether you want to use an external
Network Time Protocol (NTP) server. Enter y to use NTP, and enter your NTP server IP address(es).
Enter n to configure the date and time manually and proceed to step
=================================================================
Configure Date And Time Settings
=================================================================
The appliance date and time can be set manually or using an external
Network Time Protocol (NTP) server. It is strongly recommended that
NTP is used to configure the date and time to ensure accuracy of time
values for SNMP communications and logged events. Up to 5 server
IP addresses may be entered if NTP is used.
=================================================================
Do you want to use NTP (y/n) [y]? y
Please enter a NTP Server IP Address (Required): 144.131.10.120
Would you like to add another server (y/n) [n]? y
Please enter a NTP Server IP Address (Required): 144.131.10.121
Would you like to add another server (y/n) [n]? n
7 In the NTP validate selection screen, enter 0 to accept the current settings and proceed to the Set
Time Zone screen at step
=================================================================
NTP Servers
=================================================================
These are the currently specified NTP servers. Enter 0 or any key
other than a valid selection to complete NTP configuration and
continue.
If you need to make a change, enter the appropriate number from the
choices listed below.
144.131.10.120
144.131.10.121
0. Accept the current settings
1. Restart NTP server selection
2. Set date and time manually
=================================================================
Enter selection [0]: 0
8 If you answered no to using an NTP server to set date and time, set the date and time in the Set
Date and Time screen.
=================================================================
Set Date And Time
=================================================================
The current system date and time is: Thu Apr 24 09:34:08 2008
Please enter the values for date and time as directed where input is
expected in the following format:
MM - 2 digit month of year
DD - 2 digit day of month
YYYY - 4 digit year
hh - 2 digit hour of day using a 24 hour clock
mm - 2 digit minute of hour
ss - 2 digit seconds
=================================================================
Please enter the month [06]:
Please enter the day of the month [24]:
Please enter the year [2013]:
Please enter the hour of day [09]:
IA-A-20 and IA-A-300 Installation Guide
10 on page 17.
Configuration
8 on page 16.
16