Exposure To Radio Frequency (Rf) Signals - UTStarcom Sidekick ID Reference Manual

does cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Connect the equipment into an outlet on a circuit different from that to which the receiver

is connected.
Consult the dealer or an experienced radio/TV technician for help.

Modifications not expressly approved by the manufacturer could void the user's authority to
operate the equipment. This transmitter must not be co-located or operated in conjunction
with any other antenna or transmitter.

Exposure to Radio Frequency (RF) Signals

THIS MODEL DEVICE MEETS THE GOVERNMENT'S REQUIREMENTS FOR EXPOSURE TO
RADIO WAVES.
Your wireless device is a radio transmitter and receiver. It is designed and manufactured not
to exceed the emission limits for exposure to radio frequency (RF) energy set by the Federal
Communications Commission of the U.S. Government. These limits are part of comprehensive
guidelines and establish permitted levels of RF energy for the general population.
The guidelines are based on standards that were developed by independent scientific
organizations through periodic and thorough evaluation of scientific studies. The standards
include a substantial safety margin designed to assure the safety of all persons, regardless of
age and health.
The exposure standard for wireless mobile phones employs a unit of measurement known
as the Specific Absorption Rate, or SAR. In the United States and Canada, the SAR limit for
mobile devices used by the public is 1.6 watts/kg (W/kg) averaged over one gram of tissue.
The FCC has granted an Equipment Authorization for this wireless device with all reported
SAR levels evaluated as in compliance with the FCC RF emission guidelines. For the PV150
model, the highest SAR value when tested for use at the ear is 0.63W/kg and when worn on
the body, as described in this guide, is 0.86W/kg. SAR information on this device is on file with
the FCC and can be found under the Display Grant section of http://www.fcc.gov/oet/fccid
after searching on FCC ID: APYNAR0062 for the PV150 (850/1900MHz) model.

For body-worn operation, to maintain compliance with FCC RF exposure guidelines,
use the supplied carrying case. Use of non-approved accessories may violate FCC RF
exposure guidelines and should be avoided. When carrying the device on your person, it is
recommended to turn the screen display in toward the body in order to minimize RF exposure
and maximize antenna efficiency.
64 Handling and Safety Precautions