SPX FLOW Infinity Series Operating Instructions Manual page 6

Safety Precautions Continued
Air-Driven Motor
WARNING : To prevent personal injury,
• Install a shut-off valve or quick disconnect in the air line to the motor. Close the shut-off valve
before connecting the air line to the pump.
• Read, understand, and follow the instruction manual for the air motor.
• Disconnect the air supply and relieve pressure when the pump is not in use or when
disconnecting any connection in the hydraulic system.
• The control circuit must comply with local directives and standards.
Hoses
WARNING
: To prevent personal injury,
• Before operating the pump, tighten all hose connections using the correct tools. Do not
overtighten. Connections should be only secure and leak-free. Overtightening can cause
premature thread failure or high pressure fittings to split at pressures lower than their rated
capacities.
• Should a hydraulic hose rupture, burst, or need to be disconnected, immediately shut off the
pump and shift the control valve twice to release pressure. Never attempt to grasp a leaking
hose under pressure with your hands. The force of escaping hydraulic fluid could cause
serious injury.
• Do not subject the hose to potential hazard, such as fire, sharp surfaces, heavy impact, or
extreme heat or cold. Do not allow the hose to kink, twist, curl, or bend so tightly that the fluid
flow within the hose is blocked or reduced. Periodically inspect the hose for wear, because
any of these conditions can damage the hose and possibly result in personal injury.
• Do not use the hose to move attached equipment. Stress can damage the hose and possibly
cause personal injury.
• Hose material and coupler seals must be compatible with the hydraulic fluid used. Hoses
also must not come in contact with corrosive material such as creosote-impregnated objects
and some paints. Consult the manufacturer before painting a hose. Never paint the couplers.
Hose deterioration due to corrosive materials may result in personal injury.
• Carefully inspect all hoses and fittings prior to use. Before each use, check entire hose for
cuts, leaks, abrasion or bulging of cover, or damage or movement of couplings. If any of
these conditions exist, replace the hose immediately. NEVER attempt to repair the hose.
Cylinder
• Do not exceed rated capacities of the cylinders. Excess pressure may result in personal
injury.
• Avoid off-center loads that could damage the cylinder and/or cause loss of the load.
• Read and understand all safety and warning decals and instructions for devices attached.
• Inspect each cylinder and coupler before each shift or usage to prevent unsafe conditions
from developing.
• Do not use cylinders if they are damaged, altered or in poor condition.
© SPX FLOW, Inc. 5 Form No. 1000577
Rev. 2 Jun. 02, 2022