Mailboxes; Auto Redial; Phone Settings; Auto Switch On/Off - UTStarcom GPRS1229 User Manual

Utstar gprs1229: user manual
Table of Contents

Advertisement

Before activating this option, you must enter your voice mailbox number (see next section).
This feature is subscription dependent, and different from the call transfer, which takes
place when one/several calls are in progress.

Mailboxes

10.5.6
To enter your voice mailbox numbers (if not available on your SIM card). In some cases,
you might have to enter two numbers: one to listen to your mailbox, the other one to
forward calls. Contact your operator for more information.

Auto redial

10.5.7
When On, if the person you are calling is busy, your phone will automatically redial the
number until a successful connection is made or until the maximum number of attempts is
reached (10). The phone beeps at the beginning of each attempt and emits a special beep
if the connection is successful. The time between redials increases with each attempt.

10.6. Phone Settings

Auto Switch on/off

10.6.1
These two separate menus allow you to set your mobile phone to switch itself on or off at
pre-set times. To set Auto switch on, select the option and press [OK]. Select On and
press [OK]. Enter the time at which you want your mobile phone to switch itself on and
press [OK]. Select the desired frequency from Once, Everyday, or On weekdays and
press [OK]. A message appears to confirm activation. Proceed the same way for the Auto
switch off option.

Hotkeys

10.6.2
Allow you to establish direct access to a specific function or a contact by linking it to a
Hotkey. Pressing and holding on the key in idle mode will automatically activate the
function or call the associated number (Flash dial).
Depending on your service provider, other hotkeys may be predefined and locked.
1. In the list, select a key from
programmed, select Change.
2. Browse the list to select the function you wish to associate with this key and press [OK]
to confirm your choice. If you select Flash dial, you will be asked to select a contact in the
contacts list.
3. To use a hotkey, simply press and hold the key corresponding to the function you want
to launch or to the number you want to dial when in idle mode.
4. Hotkeys list: Flash dial, Send SMS, Read SMS, MMS, Activate silence, Activate
headset, Meeting, Activate outdoors, Activate personal, Activate Autonomy, Calculator,
Reply last No., SOS Call, Show Balance, Total cost, Add new event, Show events, Alarm
to
and press [OK]. If the key was already
39

Advertisement

Table of Contents
loading

Table of Contents