Sensor Programming By Obd - Ranger TruSensor TS58R User Manual

7. Click Clear to automatically clear the fault code and poll the ECU board to
ensure all fault codes have been deleted; or click Save to store the fault code. Saved
Fault Codes may be viewed in the "data record."

Sensor Programming by OBD

This section covers programming the new TruSensor Tire Pressure Sensors. There
are four methods to program the Sensors: Copy by OBD, Copy by Activating, and
Automatically Create ID.
Sensor Programming - Copy by OBD (ON-BOARD DIAGNOSTIC)
This section programs New TruSensor Tire Pressure
Sensors with the Sensor ID registered on the Vehicle's
Computer Board.
Note: Recommended practice is to install a new
TruSensor in the same wheel, then writes the Sensor
ID to the Computer Board without performing the
Location Learning function. This method (if available)
programs a new sensor.
To Program a New TruSensor using Copy by
OBD:
1. After Vehicle selection is complete, select
Sensor Programming then select Copy by
OBD.
TS-58R TPMS Diagnostic Tool 14
5900313 - Rev. A - March 2023