Black+Decker FSMH1351SM-QS Original Instructions Manual page 12

Use
Important! This unit will kill 99.9% of bacteria and germs
when used in accordance with the instructions in this manual
and with the micro fibre pads fitted and a continuous run
time of 90 seconds.
Switching on and off
• To switch the appliance on, press the ON/Off switch (1).
It takes approximately 15 seconds for the steam mop to
heat up.
• To switch the appliance off, press the ON/Off switch (1).
Note: always have your hand inside the SteaMittTM before
you press the steam button.
Caution! Never leave the steam mop in one spot on any
surface for any period of time.
Always place the steam mop with the handle (8) supported
in the upright position when stationary and make sure the
steam mop is turned off when not in use.
Caution! Always empty the steam mop after use.
Note! When first filled or after running dry, it can take up to
45 seconds for steam to be produced.
TM
Autoselect Technology (Fig. R)
This steam mop is fitted with an Autoselect
shows various cleaning applications. They are used to select
the correct operating mode for your particular cleaning
operation.
Using Autoselect , choose from one of the following
TM
applications by turning the Autoselect
required setting is selected.
Setting Mop
Wood/Laminate
Stone/Marble
Tiles/Vinyl
The steam mop will select the correct volume of steam
required for your particular cleaning operation.
Note: Always check you are using the correct setting before
using your steam mop.
Steam Burst (Fig. C1) (only available with
units FSMH1310SM, FSMH13151SM)
The floor head (12a) is equipped with a steam burst pedal to
aid in the removal of stubborn marks and stains.
• During use, press the steam burst pedal to apply extra
cleaning power.
• To revert back to normal setting press the pedal again.
dial (2) which
TM
dial (2) until the
TM
Hand held
High temperature steam for
windows
Low temperature steam for
heavy grime
(Original instructions)
Hints for optimum use
General
Caution: Never use the steam mop without first attaching a
cleaning pad.
• Always vacuum or sweep the floor before using the
steam mop.
• The easiest way to use the appliance is to tilt the handle
to a 45º angle and clean slowly, covering a small area at
a time.
• Use water only with no additives or chemicals with your
steam mop. To remove stubborn stains from vinyl or
linoleum floors, you can pre-treat with a mild detergent
and some water before using the steam mop.
Steam Cleaning with the mop
• Fit hand held steam cleaner (5) to the steam mop body
(11)
• Place a cleaning pad (13) on the floor with the velcro
'loop' side facing up.
• Lightly press the steam mop down onto the cleaning pad
(13).
• Connect the steam mop to the mains.
• Press the ON/OFF button (1). It takes approximately 15
seconds for the steam mop to heat up.
• Turn the AutoselectTM dial (2) until the required setting is
reached. After a few seconds steam will start to come out
of the steam head.
Note! When first filled or after running dry, it can take up to
45 seconds for steam to be produced.
• It takes a few seconds for steam to enter the cleaning
pad. The steam mop will now glide easily over the
surface to be sanitized/cleaned.
• Push and pull the steam mop slowly across the surface
to thoroughly steam clean each section.
• When you have finished using the steam mop, return the
handle (8) to the upright position, making sure that it is
supported and turn it 'OFF'. Wait until the steam mop
cools down (approximately five minutes).
Caution! It is important to monitor the water level in the water
tank. To refill the water tank and continue to sanitize/clean
stand the mop upright making sure that the handle is
supported and turn the steam mop 'OFF'. Unplug the unit
from the electrical wall outlet, and refill the water tank.
Caution! Never leave the steam mop in one spot on any
surface for any period of time. Always place the steam mop
with the handle (8) supported in the upright position when
stationary and make sure the steam mop is turned off when
not in use.
Carpet refreshing
• Place a cleaning pad (13) on the floor with the 'loop' side
facing up.
ENGLISH
11