Yamaha FGDP-50 User Manual page 79

P02 Loud1 Tx
P03 Loud2 Tx
P04 Hard1 Tx
P05 Hard2Tx
P06 Fixed Tx
P07 Normal Rx
P08 Loud1 Rx
P09 Loud2 Rx
P10 Hard1 Rx
P11 Hard2 Rx
an external tone generator via MIDI transmission from this
product.
For all Pads, "VelCurve" and "ATCurve" are set to "Loud1."
For all Pads, "MIDINote" is set based on the GM (General
MIDI) Drum Map. These settings are for controlling an
external tone generator via MIDI transmission from this
product.
For all Pads, "VelCurve" and "ATCurve" are set to "Loud2."
For all Pads, "MIDINote" is set based on the GM (General
MIDI) Drum Map. These settings are for controlling an
external tone generator via MIDI transmission from this
product.
For all Pads, "VelCurve" and "ATCurve" are set to "Hard1."
For all Pads, "MIDINote" is set based on the GM (General
MIDI) Drum Map. These settings are for controlling an
external tone generator via MIDI transmission from this
product.
For all Pads, "VelCurve" and "ATCurve" are set to "Hard2."
For all Pads, "MIDINote" is set based on the GM (General
MIDI) Drum Map. These settings are for controlling an
external tone generator via MIDI transmission from this
product.
For all Pads, "VelFixVal" and "ATFixVal" are set to "127." For
all Pads, "MIDINote" is set based on the GM (General MIDI)
Drum Map. These settings are for controlling an external
tone generator via MIDI transmission from this product.
For all Pads, "VelCurve" and "ATCurve" are set to "Normal."
In addition, "MIDINote" for all Pads is set so that the
numbers are ordered sequentially. These settings are for
controlling the built-in tone generator from an external
device via MIDI.
For all Pads, "VelCurve" and "ATCurve" are set to "Loud1."
For all Pads, "MIDINote" is set so that the numbers are
ordered sequentially. These settings are for controlling the
built-in tone generator from an external device via MIDI.
For all Pads, "VelCurve" and "ATCurve" are set to "Loud2."
For all Pads, "MIDINote" is set so that the numbers are
ordered sequentially. These settings are for controlling the
built-in tone generator from an external device via MIDI.
For all Pads, "VelCurve" and "ATCurve" are set to "Hard1."
For all Pads, "MIDINote" is set so that the numbers are
ordered sequentially. These settings are for controlling the
built-in tone generator from an external device via MIDI.
For all Pads, "VelCurve" and "ATCurve" are set to "Hard2."
FGDP-50 User Guide
79