Multifunction Digital Computer C 364 - APRILIA SR 50 Workshop Manual

PERIODIC MAINTENANCE
SR 50
2.1.6.

MULTIFUNCTION DIGITAL COMPUTER C 364

Multifunction indicator functions
Use the Mode button (2), on handlebar left side, to select
among various functions: clock setting, odometer (ODO), trip
meter (TRIP), battery voltage value and trip meter reset.
Odometer (ODO).
When the instrument panel is switched on, the multifunction
display (1) shows the odometer function (ODO).
TRIP.
With the odometer display (ODO), press the Mode button (2)
once to display the function (TRIP). Hold down the Mode
button (2) for at least three seconds to reset stored trip
value.
Battery voltage.
With the odometer display, press the Mode button (2) twice
to display the battery function.
Conversion of unit of measurement - Km/Mi
When battery voltage is displayed on multifunction display
(1), hold down the Mode button (2) for more than ten
seconds to change the unit of measurement from kilometres
(Km) to miles (Mi). While pressing the button, the current unit
of measurement is flashing. Should the button be pressed for
less than ten seconds, the conversion will not take place.
Setting the clock
CAUTION For safety reasons, it is possible to set this
function when vehicle is stopped only.
Hold down the Mode button (2) for at least three seconds.
The column dividing hours and minutes will start flashing.
Set the hour value, it will increase by one unit every time you
press the Mode button (2).
Hold down the Mode button (2) again for at least three
seconds to shift to minute setting. The indicated value will
increase by one unit every time the Mode button (2) is
pressed.
Hold down the Mode button (2) for at least three seconds to
go back to hour setting.
If no key has been touched for three seconds, the display will
automatically quit the clock setting function.
2 - 18
WWW.PlanDeGraissage.ORG