APRILIA SR 50 Workshop Manual page 46

SR 50
CHANGE
• Position the vehicle on firm and flat ground.
•
Position the vehicle on the centre stand.
WARNING
Allow several minutes for the engine and
exhaust system to cool down.
• Stop the engine and let it cool down, in order to allow
the oil to flow into the crankcase and to cool down.
•
Unscrew and extract the plug/dipstick.
•
Take a container of suitable capacity and set it under
the drain screw.
• Release and remove the drain screw.
•
Let fluid fully drain inside the container.
WARNING
Used oil contains substances that are very
dangerous for the environment. Dispose of
used oil in accordance
regulations.
•
Fit and tighten the drain screw.
•
Pour oil through the transmission oil filler hole.
• Screw and tighten the plug/dipstick.
• Start the engine and let it run for a few minutes. Stop
the engine and let it cool down.
•
Check gear fluid level.
WWW.PlanDeGraissage.ORG
with applicable
PERIODIC MAINTENANCE
2 - 27