Table of Contents
Advertisement
Suunto Spartan Sport Wrist HR
3.23. Pairing PODs and sensors
Pair your watch with Bluetooth Smart PODs and sensors to collect additional information, such
as cycling power, when recording an exercise.
Suunto Spartan Sport Wrist HR supports the following types of PODs and sensors:
Heart rate
•
Bike
•
Power
•
Foot
•
NOTE: You cannot pair anything if airplane mode is on. Turn off airplane mode before
pairing. See 3.2. Airplane mode.
To pair a POD or sensor:
1. Go to your watch settings and select Connectivity.
2. Select Pair sensor to get the list of sensor types.
3. Swipe down to see the whole list and tap on the sensor type you want to pair.
4. Follow the instructions in the watch to complete pairing (refer to sensor or POD manual if
needed), pressing the middle button to advance to the next step.
If the POD has required settings, such as crank length for a power POD, you are prompted to
enter a value during the pairing process.
Once the POD or sensor is paired, your watch searches for it as soon as you select a sport
mode that uses that sensor type.
You can see the full list of paired devices in your watch from the settings under Connectivity »
Paired devices.
From this list, you can remove (unpair) the device if needed. Select the device you want to
remove, and tap Forget.
3.23.1. Calibrating foot POD
When you pair a foot POD, your watch automatically calibrates the POD using GPS. We
recommend using the automatic calibration, but you can disable it if needed from the POD
settings under Connectivity » Paired devices.
For the first calibration with GPS, you should select a sport mode where the foot POD is used
and the GPS accuracy is set to Best. Start the recording and run at a steady pace on a level
surface, if possible, for at least 15 minutes.
29
Advertisement
Table of Contents
