Download Print this page
Topeak WhiteLite HP 2W User Manual

Topeak WhiteLite HP 2W User Manual

Advertisement

Quick Links

IMPORTANT
Although light body and battery are water-resistant
(under normal weather conditions of rain, etc..)
never intentionally submerge them under water.
The battery used in the WhiteLite HP 2W lighting
system is 7.4 volts. Never attempt to alter this
lighting system. Never use this battery with any
other lighting or electrical system.
Never attempt to disassemble the battery.
If battery pack is dropped, battery case may be
cracked and a short circuit may occur. Replace
battery pack immediately.
The battery has unique characteristics. The light
output will remain high until the battery runs down
then drops suddenly. Always pay attention to the
charge remaining and take precautions by carrying
a spare battery.
The battery charger is for indoor use only. After
charging the battery, be sure to unplug it from the
home power outlet.
After a long period of non-use, the battery will lose
charge. Always fully charge the battery before
each use.
If the light body or parts become dirty, gently clean
with a soft towel using mild soap and water. Never
use harsh chemicals to clean the lighting system
as damage to housings will occur.
When connecting and disconnecting the plug and
socket hold the connector ends only. Do not attempt
to connect or disconnect the plug/socket interface
by pushing or pulling on wires or serious damage
to wires and connectors will occur.
After long periods of non-use, the battery will lose
charge. Always charge the battery fully before
each use and storage. Maintain the battery by
charging it every three months and storing it in a
cool, dry place to prevent from decreasing its
lifespan. 3 to 5 charging cycles are needed to attain
full capacity after a long period of non-use.
G
B
6
WARNING
Pace maker users should never use this device.
The light body becomes extremely hot when used
for long periods of time. Never touch the body or
lens until it has thoroughly cooled, otherwise injury
may occur.
Never look directly into the light when it's turned
on. It may harm your eyesight.
Do not use this light improperly on public roads.
The light output is equal to automobile halogen
bulbs. Adjust the light accordingly so as not to
blind oncoming traffic.
If the light unit, cord or battery pack is damaged,
discontinue use immediately. A hazardous condition
may result due to the high voltage system.
Never short-circuit the terminals of the battery
pack or the plug of the components.
Safely and properly dispose of the old Li-ion
batteries according to your local regulations.
Never place this lighting system within a child's
reach.
Use only the supplied battery charger for this
system.
Night riding is inherently more dangerous than
daylight riding. For your safety and the safety of
others, Topeak asks that you use extreme caution
when using this or any other light source while
riding at night.
Stay alert and ride safely while using your WhiteLite
HP 2W lighting system.
If the lighting system turns off automatically, DO
NOT attempt to turn on the lighting system again,
or damage and/or decreased battery life may occur.
Never unplug light from battery when in use.
Doing so may cause damage to the system.
Prepare to Ride
WhiteLite
WhiteLite HP 2W is equipped with standard
mounting parts for Handlebar.
Please read all instructions before first use.
Power Controller
Power Level
Indication
1W
Red
2W
Press and hold for
Blue
3 seconds
to turn on or off
Low Battery
Red
Thank you for purchasing the Topeak WhiteLite HP 2W. Designed for high performance night cycling. This is a
unique high power 7.4 volt lighting system. Before operating, thoroughly familiarize yourself with this manual
so that you understand the light's safe and correct operation. Please keep this manual for further reference.
Before first use, the battery pack must be fully charged. (Please follow the instructions
on BATTERY PACK CHARGING.) When the battery pack has not been used for a long period,
operating time will shorten due to self-discharging properties of the Li-ion battery.
HP
2W
TM
User's Guide
Battery:
TMS030
TMS029
Mount on Handlebar
GB
Li-ion 7.4 V
G
B
1

Advertisement

loading
Need help?

Need help?

Do you have a question about the WhiteLite HP 2W and is the answer not in the manual?

Questions and answers

Summary of Contents for Topeak WhiteLite HP 2W

  • Page 1 Doing so may cause damage to the system. Mount on Handlebar Thank you for purchasing the Topeak WhiteLite HP 2W. Designed for high performance night cycling. This is a unique high power 7.4 volt lighting system. Before operating, thoroughly familiarize yourself with this manual so that you understand the light's safe and correct operation.
  • Page 2 1-1 Light cover 1-2 Light Body 1-3 Battery Pack Connecting Plug 2. Battery Pack (#TMS-SP65) Remove stem cap and replace with 2-1 Battery the Topeak battery holder unit. 2-2 Power-Controller 2-3 Socket 2-4 2-5 2-4 Release Button Optional mounting position (B)
  • Page 3 HANDLEBAR SPARE PARTS WhiteLite HP 2W lighting system includes a Safety Time Reserve tank that provides up to 30 minutes of additional burn time at 1 W. The light will shut off automatically after RED power-indicator blinks for 1 minute. For continued "Click"...