Emergency Alarm - Tait TM2210 Instruction Manual

Instruction Manual
2. Within the scan suspension duration, press the PTT key. The red LED indicator light will be on.
3. After the prompt tone for talk (if enabled) is over, speak into the microphone.
4. To receive voice, release the PTT key.
5. If you do not reply within the scan suspension duration, the radio will resume channel scanning.
5.2.4 Deleting Noise Channel
If noise frequently occurs in a channel, you may delete the channel from the scan list by pressing the key
programmed as "Delete Noise Channel".
Note:
A prior channel or a selected channel or the only one channel in a scan list cannot be deleted.

5.3 Emergency Alarm

Under emergency, you can send an emergency alarm to another user or the control center by pressing the
Emergency Alarm key. Emergency alarm has the highest priority, so you can send an emergency alarm at any
time, no matter the radio is transmitting or receiving traffic.
The radio supports three emergency alarm modes, and you can have one mode set by your dealer.
Emergency Alarm Only

In this mode, you can send an alarm message but cannot talk to a user or the control center by pressing the
Emergency Alarm key.
Emergency Alarm and Call

In this mode, you can send an alarm message by pressing the Emergency Alarm key, and send voice and
22
TM2210 Digital Mobile Radio TM2210 Digital Mobile Radio
background tone by pressing the PTT key and talking into the microphone.
Emergency Alarm Followed by Voice

In this mode, you can send an alarm message by pressing the Emergency Alarm key, and send voice and
background tone by talking into the microphone. You don't need to press the PTT key.
In any of the above modes, there are four alarm types. You can have one type set by your dealer.
Siren Only

During an emergency alarm, siren is given off on the radio, but the control center does not receive an alarm
signal.
Normal

During an emergency alarm, there is audio-video prompt.
Secret

During an emergency alarm, there is no audio-video prompt. The speaker is not turned on when speech is
received unless the PTT key is pressed.
Secret with Voice

During an emergency alarm, there is no audio-video prompt, but call can be received. There is no audio-video
prompt when speech is received unless the PTT key is pressed.
5.3.1 Sending Emergency Alarm
To send an emergency alarm, press the Emergency Alarm key. The emergency alarm icon
in the status bar, and the alias or ID of an emergency group call, emergency alarm icon
Instruction Manual
will be displayed
and outgoing
23