Table of Contents
Advertisement
Care, maintenance and repair
Lowering the load
ATTENTION!
Risk of injury!
Do not place body parts (hands, feet) under the
forks or between the scissors when a load is lifted or
lowered.
To lower the fork, pull the control lever for the hydraulic
pump to the upper position and hold it: The fork is lowe-
red.
When released, the lever automatically returns to the
middle position.
When the load is safely lowered and the fork is free, ex-
tend the pallet truck under the load.
Lifting and lowering the load can be interrupted at any
stage of the operation. The load is held securely in its
current position.
Manoeuvring the pallet truck
ATTENTION!
- Never move the pallet truck on a slope or sloping
surface.
- Observe different surface structures
- The load must be secured against falling down.
- Observe the longer stopping distance corres-
ponding to the load. Use the brake, if available.
To manoeuvre the pallet truck, always move the control
lever for the hydraulic pump to the middle position. This
makes manoeuvring easier and increases the service
life of the seals in the hydraulic pump, as it is ineffective
in the middle position of the lever.
To manoeuvre the pallet truck, push or pull it, for lateral
movements turn the control drawbar to the right or left
while doing so.
In order to protect the wheels and the chassis of the
pallet truck, do not drive over large uneven surfaces
(potholes, thresholds, etc.).
To lift the forks, push the control lever for the hydraulic
pump into the lower position, the lever engages. Then
move the control drawbar up and down, the forks are lif-
ted.
To lower the forks, pull the control lever for the hydraulic
pump into the upper position and hold, the forks are
lowered. When released, the lever automatically returns
to the middle position.
Lifting and lowering the load can be interrupted at any
stage of the operation. The load is held securely in its
current position.
If the pallet truck gets out of control on a slope, the pallet
truck can be braked by carefully lowering the load.
10
10 Care, maintenance and repair
ATTENTION!
- Maintenance and repair work may only be carried
out by qualified personnel.
- Before starting cleaning and service work, remove
the load and place the forks in the lowest position.
Park the pallet truck firmly and secure it against
rolling away.
- Only use original spare parts.
- Oil leaks can cause damage and accidents!
- Adjustment of the pressure valve may only be car-
ried out by qualified service technicians.
- Waste materials such as oil, used batteries must be
disposed of in accordance with local regulations or
handed over to a recycling company.
- Before completing maintenance work, ensure that
all cables are correctly connected and all safety
covers are correctly fitted.
10.1 Care by cleaning
The scissor pallet truck must always be kept in a clean
condition.
Use protective gloves!
NOTE!
Never use strong cleaning agents to clean the de-
vice. Such cleaning agent might damage or destroy
the device.
All plastic and lacquered surfaces should be cleaned a
soft, damp cloth and a neutral cleaning agent.
10.2 Maintenance and repair
The mechanical and general condition of the pallet truck
must be checked by a specialist workshop at least
every 12 months.
Maintenance work may only be carried out by qualified person-
nel with mechanical knowledge.
ATTENTION!
All protective and safety devices must be reinstalled
immediately after completion of repair and main-
tenance work.
PHH 1001 | Version 2.03
Advertisement
Table of Contents
