Table of Contents
Advertisement
3.2 Installing the Siphon Pump
When installing the pump at the panel unit
(separately available) or the mounting bracket,
observe the following procedure. (When
purchasing the panel unit separately)
1)
Loosen the bolt of the pump fixing band
mounted on the mounting bracket and
remove the band.
2)
Putting the flange surface of the pump on
the bracket, screw the support bolt with the
pump fixing band and fix it.
3)
Remove the plug at the injection port (2B) of
the drum can and screw the bang adapter
attached to the suction hose assembly
(separately available).
Connect the pump to the suction hose
assembly and insert the suction tube in the
drum can. Make a clearance between the
lower end of the tube and the bottom of the
drum can and tighten the thumb screw of the
bang adapter to fix the suction hose assembly.
(Fig. 2)
[NOTE]
When installing the panel unit and the
mounting bracket on the wall, select a place
that permits secure fixing and can withstand
vibrations. (Fig. 2 and 3)
3.3 Installing the Draw Change Material Hose
1)
Install the material hose (separately available) at the material discharge port (Rc3/4) of the pump.
Tighten the union with a spanner so as not to make the material hose loose. In this case, wind the
seal tape that is available on the market around the male screw of the hose and then screw it.
2)
Install the gun fit for the application at the end of the hose.
3.4 Installing the Pressure Feed Material Hose
For pressure-feeding oil by piping at a long distance, observe the following procedure.
- Do not connect the pump directly to the piping. Otherwise, when the pump is operated, the piping
is damaged, the pump generates large noise, the pump does not permit changing the drum can,
and the pump cannot be serviced. Be sure to connect a flexible hose between the pump and the
piping.
Fig. 2
Vent
plug
Bang
adapter
2 - 3 cm
Fig. 3
Mounting bracket
Hose union
Material hose
WARNING
3
Steel pipe
High–pressure valve
Material hose
Air hose
Air
regulator
Panel unit
Band
Suction hose
Ass'y (850126)
Air hose
Air regulator
Advertisement
Table of Contents
