Table of Contents
Advertisement
3.2 Installing the Siphon-Pump
When installing the pump at the panel
unit
(separately
mounting bracket, observe the following
procedure.
(When purchasing the panel unit
separately)
1) Loosen the bolt of the pump fixing band
mounted on the mounting bracket and
remove the band.
2) Putting the flange surface of the
pump on the bracket, screw the
support bolt with the pump fixing
band and fix it.
3) Remove the plug at the injection port (2B) of
the drum can and screw the bang adapter
attached to the suction hose assembly
(separately available).
4) Connect the pump to the suction hose
assembly and insert the suction tube
in the drum can.
between the lower end of the tube and the
bottom of the drum can and tighten the thumb screw of the bang adapter to fix the suction
hose assembly. (Fig. 2)
[NOTE]
When installing the panel unit and the mounting bracket on the wall, select a place that
permits secure fixing and can withstand vibrations. (Fig. 2 and 3)
- When using a vessel with cover such as drum can, be sure to loose the vent plug
so that the inside of the vessel may not form a vacuum.
3.3 Installing the Draw Change Material Hose
1) Install the material hose (separately available) at the material discharge port (Rc 3/4) of the
pump. Tighten the union with a spanner so as not to make the material hose loose. In
this case, wind the seal tape that is available on the market around the male screw of the
hose and then screw it. (Fig.3)
2) Install the gun fit for the application at the end of the hose.
available)
or
the
Make a clearance
CAUTION
Fig-2
Bent
plug
Bang
adapter
2～3 cm
Fig-3
Mounting bracket
Hose union
Material hose
3
Steel pipe
High–pressure valve
Material hose
Air hose
Air
regulator
Panel Ass'y
Band
Suction hose
Ass'y (850126)
Air hose
Air regulator
Advertisement
Table of Contents
