Error Codes - Webasto SmartControl Operating Instructions Manual

3
Error message is shown in the display.
Press the con tro l knob in order to confirm
X X
error message.
Error message is stored in error memory. If error
message is not confirmed then it will be displayed
during each restart/waking up from the stand-by
mode.
6.1

Error codes

If error message appears in the display, please contact the technical support/
X X
customer service.
NOTE:
Inspections and repairs can only be carried out by trained
personnel!
Examples of error messages for control elements:
Code Description
T84 Undervoltage (supply voltage is below 8V)
Charge the battery and check car electrical installation.
X X
Te4 Defective LED status
Contact technical support/customer service.
X X
Te5 Temperature sensor failure (temperature sensor in MultiControl/Smart-
Control is damaged)
X X Contact technical support/customer service.
www.butlertechnik.com
www.butlertechnik.com
54