Makita VC2211M Technical Information page 9

R
epair
[3] DISASSEMBLY/ ASSEMBLY
[3]-2. Inner cover
DISASSEMBLING
(1) Turn the assembly of Inner cover and Tank cover complete upside down, then raise Lock lever to remove
two Pre-filters. (Fig. 25)
(2) Remove eight 4x35 Tapping screws that fasten Inner cover to Tank cover complete. (Fig. 26)
Three of the eight screws are used also to fasten Protector to Inner cover. So, first pull off Terminal of two Lead units
from Water level sensors of Protector, then remove Protector from Inner cover and then remove Inner cover from
Tank cover complete. (Fig. 27) Rubber ring and Seal ring can now be removed from Tank cover.
(3) Remove two Inner valve completes, then remove Cam by removing Retaining ring S-20. (Fig. 28)
Fig. 25
Lock lever
Tank cover complete
Fig. 27
Inner cover
Pre-filter
Inner cover
Protector
Water level sensor
Terminal of Lead unit
Fig. 26
Fig. 28
Inner valve complete
Retaining ring S-20
P 9/ 21
4x35 Tapping screw (8 pcs.)
Inner cover,
viewed from bottom
Cam