Makita VC2211M Technical Information page 8

R
epair
[3] DISASSEMBLY/ ASSEMBLY
[3]-1. Motor section (cont.)
ASSEMBLING
(11) Install two Outer valve completes in place as shown in Fig. 22.
Note: Be careful not to move them out of place when installing Separator complete in step (13) below.
(12) Assemble DC motor unit. [Refer to step (6) and Fig. 6 of "DIS
Note: When installing DC motor on Gear case, insert the positioning pin of Gear case into the positioning hole of
DC motor. (Fig. 23)
(13) Put Separator complete on Tank cover complete, then put DC motor unit in place; at this time, do not forget to
engage the two flats of Spindle with those of Cam's hole.
Note: Do not forget to place DC motor seal between Separator complete on Tank cover complete.
Note: Apply Makita grease FA No.2 to the gear chamber of Gear case to prevent Spindle assembly from falling off
from DC motor unit.
(14) Fasten Separator complete and DC motor unit to Tank cover complete with seven 4x35 Tapping screws,
then insert Vinyl tube into place. [Refer to Fig. 4 of "DIS
(15) Fit Switch base E-M complete in Cowling complete, then put Cowling complete over Separator complete;
be sure to fit the top end of Switch base E-M complete in the groove inside Cowling complete to prevent
Switch base E-M complete from falling out of place. (Fig. 24)
And then fasten Cowling complete to Separator complete with nine 4x35 Tapping screws.
Fig. 22
Outer valve complete (2 pcs.)
Fig. 24
Cowling complete,
viewed from bottom
groove inside
Cowling complete
Tank cover complete
top end of
Switch base E-M complete
Switch base E-M complete
".]
ASSEMBLING
".]
ASSEMBLING
Fig. 23
Gear case
positioning pin
groove inside
Cowling complete
P 8/ 21
DC motor
positioning hole
Cowling complete
Separator complete