Makita VC2211M Technical Information page 4

R
epair
[3] DISASSEMBLY/ ASSEMBLY
[3]-1. Motor section (cont.)
DISASSEMBLING
(7) Take two Closed end splices (Connector 2-SD) out of the splice storage compartment to allow the lead wire of each of
two Lead units to have slack in it. (Fig. 7)
(8) With the lead wire of Lead units slack, remove Separator complete from Tank cover complete.
then remove AC motor unit. (Fig. 8)
Fig. 7
Separator complete
viewed from top
Fig. 8
(9) Remove Motor cover from AC motor unit, then remove
Fan 62 by turning it clockwise fast by hand.
If Fan 62 cannot be removed by hand, turn it by pushing
the fan blade with a small slotted screwdriver as shown
in Fig. 9.
Note: Be careful not to deform the fan blade with the
screwdriver.
Separator complete
Fig. 9
P 4/ 21
Motor cover