HAMPTON BAY LELAND II Use And Care Manual page 17

Troubleshooting (continued)
Problem Problem
The lights shut off and will
not come back on.
The fan wobbles.
Solution Solution
□
This unit is equipped with a wattage limiting device. Lamping in excess of 190 watts will disable your
ceiling fan's light kit. To reset your light kit you must turn the power off and relamp, keeping the
wattage under 190 watts. Restore power to your ceiling fan and continue normal operation.
□
Check that all blade and blade arm screws are secure.
□
Most fan wobble problems are caused when blade levels are unequal. Check this level by selecting a
point on the ceiling above the tip of one of the blades. Measure from a point on the center of each blade
to the point on the ceiling. Rotate the fan until the next blade is positioned for measurement. Repeat for
each blade. Measurement deviations should be within 1/8 inch. Run the fan for ten minutes.
□
Use the enclosed blade balancing kit if the blade wobble is still noticeable.
17
Please contact 1-877-527-0313 for further assistance.
HAMPTONBAY.COM