Advertisement
2
FIT AND SECURE
2.1
2.2
2.3
RRAC242_REV_A00
9
5
7
11
3
10
12
2
Loosen and remove the front slat.
Torx
T30
Keep screws to one side to use later.
Cordless
Driver
Slide The M8 x 20 Hex Bolt (Item 11) in the
the Slat that was removed in 2.1 at the
Torx
bottom and the top as shown.
T30
Place the Wind Fairing Center support
Bracket (Item 3) on the M8 x 20 Hex Bolt
(Item 11) at the bottom of the Slat together
with the M8 Flat Washer, M8 Nyloc Nut and
M8 Nut Cap (Item 9, 10 & 12)
Cordless
Driver
Centralize the Support Bracket and tighten
the M8 Nyloc nut and place the M8 Nut Cap
on the Nyloc nut.
Assemble the Light Bar Bracket L/H & R/H
13mm
(Item 5 & 7) on to the M8 x 20 Hex bolt (Item
11) together with the M8 Flat washer, M8
Nyloc Nut and M8 Nut Cap (Item 9, 10 & 12)
Refit The Front Salt that Was Removed into
the lower holes of the Foot Rail As Shown.
Assemble the Wind Fairing Outer Support
Bracket on the L/H and R/H (Item 2 & 4)side
Torx
as shown with the M6 Button Head Flange
T30
Bolts (Item 8).
Slide The Light Bar Brackets to desired
position and fully Tighten,
Cordless
Driver
8
3
© 2023 FRONT RUNNER VEHICLE OUTFITTERS
Advertisement
