TVS PT262 User Manual page 2

Thanks for purchasing TVS PT-262 POS Terminal. This is a powerful, easy-to-use high-quality piece of commercial equipment. It can
work independently and also work with other peripherals like Bar code scanner or weighing scale. PT262 Also supports bi-directional data
communications when connected to a computer. It can improve efficiency in both data entry and recording of transaction when connected
to computer. This manual helps you to understand, program and operate PT262 We request you to go through this manual familiarize
yourself with the machine's operation and use.
Follow these precautions to prevent any damage to the unit and against potential hazards like electric shock.
1. Remove protective devices before installation. Preserve unused accessories, CD and packing materials for future
use.
2. While installing this ECR, please plug the register into a grounded outlet. And keep the wires and electrical outlet
in the dry place.
3. For a complete electrical disconnection, switch off and remove plug from mains. Be very careful for the manual
cutter mounted on the printer cover when removing and replacing the cover, so as not to hurt you.
4. Install the cash register in a location not subject to direct sunlight, unusual temperature changes, high humidity, or
splashing water.
5. Never alter or add to the mechanical or electrical design of the ECR. Unauthorized alterations might create a
safety hazard. Also, any design changes or additions will void the manufacturer's warranty.
6. Never operate the cash register with wet hands. Water can cause internal component failure.
7. Clean the cash register with a dry, soft cloth. Never use volatile liquid, such as benzene or thinner. Chemicals can
discolor or damage the cabinet.
8. The cash register has two types of turning off. One is hard turning off using power switch located at rear side.
With this type, the standby power supply of main board supplies only for RAM, which stores the sales data. This
can prevent stored data from losing. The other is soft turning off (i.e. press key [CLERK] to switch to off mode).
There is nearly no power consumption. We suggest that you'd better select soft turning off (press key [
wake it up).
9. This cash register is an energy-saving machine. If AC is lost, after 30 minutes idles, ECR enters sleeping mode.
The switch on back panel is used for long-term storage or special maintenance. In daily usage, operator should use
soft switch on keyboard instead of turning on/off this switch. In case the switch in back panel need to be used,
make sure before it is turned on again, it should be turned off for at least 4 minutes.
10. If there are register malfunctions, call your local dealer for service – do not repair the ECR yourself.
11. Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type
recommended by the manufacturer.
12. This cash register has embedded battery. You can use it without other power supply. But you had better operate
with charging if possible. It does no damage to the battery because of the embedded circuit protection.
13. This model of cash register has two battery voltage warning classes. The first warning class occurs when battery
voltage is below 6.0v, and ‗low B' which means low battery voltage will be displayed. The cash register beeps
every 5 seconds when it is idle in the first warning class. The second warning class occurs when the battery
voltage is below 5.8v, and ‗low A' displayed. The cash register is out of work and immediate charge needed.
Otherwise, using life of battery will be shortened and the stored data in the memory will lose most probably after a
long time.
14. The battery will discharge very slowly when not in use. Charge the battery twice a year when you do not use it and
do charge for 6 hours each time.
15. All pictures in this user manual are for reference only. Please subject to the available products.
PRECAUTIONS
1-2
PT - 262
] to