Paper Installation - TVS PT262 User Manual

3 PAPER INSTALLATION

1. Release and remove the paper compartment cover.
2. Remove any paper residue, foreign matter and dust from the roll housing.
3. Place the receipt paper roll in the house.
4. Insert the leading edge into the printer slot. Then press the [FEED] key to advance the paper more if required.
5. Close the cover of the paper compartment after you have caused the end of the ticket roll come out from the slot in
the cover.
1
3
Notes:
1. There is a colored band in the last length of the receipt paper roll to indicate that it is going to run out.
2. To open the paper out sensor: please turn off ECR and then turn it on without paper under the printer; within
10 second, at its initial status, please press [FEED] key for about 5 seconds not releasing the key until the paper
out alarm is appeared. With the paper out sensor, when there is no paper the ECR will beep urgently and
prompt "ERR 80 No paper roll" on LCD, which indicates to install the paper roll. Once detecting paper, it will
print a short length of paper. Meanwhile, it beeps lenitively ten times instead which reminds to make the
receipt paper ready for printing. When ECR stops beeping, it prints the unfinished task automatically.
3. To close the paper out sensor: please turn off ECR and then turn it on without paper under the printer; within
10 second, at its initial status, please press [FEED] key for about 5 seconds not releasing the key until the paper
out alarm is disappeared.
2
4
PT - 262