Table of Contents
Advertisement
OPERATION
ADJUSTMENTS OF THE CENTRAL LUBRICATION
SYSTEM
Manual actuation Mode of the Lubrication System
with Service Key
The manual actuation in the Service mode is useful for testing the
electrical and hydraulic functions of the of the lubrication system.
The pause time is reduced to 30 seconds and the holding time to
15 seconds permitting rapid sequences of lubrication cycles. Both
lubrication systems can be set to the manual actuation mode.
In the manual actuation mode all monitoring functions of the
system are made inoperative and, because of the very short
pause and holding times, grease will not reach to all lubrica-
tion points.
Carry out manual lubrication by using the service key
1. Insert key into service switch (3) and set to operating position.
2. Actuate the rotary switch (1) on the instrument panel. The
message # SERVICE appears on the display. Up to ten
repeated actuation of the switch are possible. The lubrication
cycles are counted and displayed in the cycle counter win-
dow.
3. After finishing the manual lubrication remove service key. The
system returns to the normal timer settings.
Adjustments of the Central Lubrication System
The following adjustments can be made with the menu control of
the ECS system:
Level 4: Service / Settings
- 4 - Settings
* CONDITION INDICATION *
- 4 - Settings (minutes)
* PAUSE TIME : *
- 4 - Settings
* LUBE CYCLE COUNTER : *
Refer to section "ELECTRONIC MONITORING AND CONTROL
SYSTEM ECS" for description of adjustment procedure.
CAUTION
3.17 OPERATION OF THE LUBRICATION SYSTEM
269
Advertisement
Table of Contents
