Magnavox MMA3727 - Stereo Portable Speaker with Bluetooth Wireless Technology Manual

LOCATION OF CONTROLS

1. Button
2. (BT) Button
3. Button
4. Button
5. M (Mode) Button
6. Button
7. Microphone
8. White Indicator
9. DC 5V (Micro USB) Port (For charging only)
10. Red Charge Indicators
11. TF (Micro SD Card) Slot
12. USB Port
13. AUX (Aux /Line In) Jack

POWER SOURCE

The unit has a built-in Li-ion rechargeable battery, charge it before first time use or when it is drained as follows:

1. Connect the small plug from the supplied USB Connection Cable to the DC 5V (Micro USB) Port on the rear of unit.
   
2. Connect the full size USB Plug from the supplied USB Connection Cable to the USB Port on the Personal Computer or USB Charger (Personal Computer and USB Charger not included).
3. When charging, the Red Indicator on the rear of unit will illuminate. When charging is complete, it will turn off.
4. During charging, you can also play and listen to music at the same time.

Notes:
Your battery will last longer if you following these simple guidelines for caring and storing:

1. Before first time use, recharge the unit approximately 4 hours until the unit is fully charged.
2. Charge and store the unit within the temperature range of 5°C - 35°C (40°F - 95°F).
3. Do not overcharge (longer than 24 hours). Excessive charging or running the unit until battery fully drains will damage battery. Battery life will be extended if you keep the battery fully charged.
4. Battery life naturally shortens slowly over time.
5. The rechargeable battery incorporated in this product is not user replaceable.

OPERATION

General Operation

1. Recharge the built-in Li-ion battery as previously instructed.
2. Press and hold the "Power Button" on the top of unit approximately half of a second second to power on the unit. The White Indicator and the control buttons on a top of unit will illuminate.
3. Press the M (Mode) Button repeatedly to switch to desired playback mode or press the (BT) Button enter to BT (Bluetooth) mode directly. The unit will sound a prompt with your selection (see list below):

Note:
If the Audio Connection Cable; TF (Micro SD) Card and/or USB Device had NOT inserted into the unit, the corresponding selection will not available.

4. During playback:
   • Press the Button to pause; press again to resume to normal playback.
     (In AUX mode, press it to mute the sound, press again to turn the sound back)
   • Press and release the or buttons repeatedly to adjust the volume level as desired.
   • Press and hold the or buttons repeatedly to skip tracks.
     (It will not functioning in AUX mode.)
5. When finished listening, press and hold the "Power Button" approximately 1 second to shut off the unit.

BT Mode

BT (Bluetooth) pairing:
First time use or re-pairing the unit to a new BT Device, pair as follows:

1. Power on the unit and enter to BT mode as previously instructed. You will hear an audible prompt say "Bluetooth ready for connection" and the White Indicator on the top of unit will illuminate and blink.
2. Power on the external BT Device and enter to BT search mode. Start pairing following the on screen instructions from the external BT Device. When paired, the unit will sound a prompt "Bluetooth connected" and the White Indicator will stop blinking.
3. If pairing is complete you may now play music and answer the phone with your external BT Device.
4. During playback:
   • Press the Button on the unit to pause; press again to resume to normal playback.
   • Press and release the or buttons repeatedly to adjust volume level as desired.
   • Press and hold the or buttons repeatedly to skip tracks.
5. If the unit is paired to a Cell Phone:
   • When a call is incoming during an active music session:
     • Press the Button then speak to the Microphone to answer the call. When your call is complete, press the Button to disconnect or end the phone call and resume to music playback.
     • Or, press and hold the Button approximately 1 second to decline the incoming phone call then resume to music playback.
   • Quick press the Button twice to redial the last telephone number your cell phone called.
6. When finished listening, press and hold the "Power Button" approximately 1 second to shut off the unit.

Notes:

• When the external BT Device searches for the unit, our model number "MMA3727" will appear on the display of external BT Device.
• If while pairing you are asked for a code, please try "0000" or "1234".

Normal operation after pairing:

1. Power on the external BT Device and enter to BT playback mode.
2. Power on the unit and enter to BT mode as previously instructed. You will hear an audible prompt say "Bluetooth ready for connection" and the White Indicator on the top of unit will illuminate and blink.
3. Wait a few seconds until the unit is automatically paired to the external BT Device. The unit will sound a prompt "Bluetooth connected" and the White Indicator will stop blinking.
4. After pairing is complete you may now play music and answer calls with your external BT Device.

AUX (Aux/Line in)

To listen from an external Audio Player such as MP3 Player, Discman...etc.

1. In power off mode, connect one end of the supplied Audio Connection Cable to the AUX Out / Line Out / Phone Jack on the external Audio Player.
2. Connect the other end of the cable to the AUX (Aux/ Line In) Jack on the rear of unit as illustrated below:
   
3. Power on the unit and enter to AUX mode as previously instructed, you will hear an audible prompt say " Line In".
4. Play the music on the connected Audio Player as usual. (Make sure the volume level of the connected Audio Player is turned to high level.)
5. During playback:
   • Press the Button to mute the sound, press again to turn the sound back.
   • Press and release the or buttons repeatedly to adjust volume level as desired.
6. When finished listening, press and hold the "Power Button" approximately 1 second to shut off the unit.

USB

To play the music in USB Device:

1. In power off mode, connect the USB Device (not included) into the USB Port on the rear of unit as illustrated below:
   
2. Power on the unit and enter to USB mode as previously instructed:
   • You will hear an audible prompt say "USB".
   • Music in the USB Device will be playback automatically.
3. During playback:
   • Press the Button on the unit to pause; press again to resume to normal playback.
   • Press and release the or buttons repeatedly to adjust volume level as desired.
   • Press and hold the or buttons repeatedly to skip tracks.
4. When finished listening, press and hold the "Power Button" approximately 1 second to shut off the unit.

Micro SD Card

To play the music in TF (Micro SD) Card:

1. In power off mode, insert the TF (Micro SD) Card (not included) into the TF (Micro SD) Card Slot on the rear of unit with contacts facing down as illustrated below:
   
2. Power on the unit and enter to TF (Micro SD) Card mode as previously instructed:
   • You will hear an audible prompt say "Memory Card".
   • Music in the card will be playback automatically.
3. During playback:
   • Press the Button on the unit to pause; press again to resume to normal playback.
   • Press and release the or buttons repeatedly to adjust volume level as desired.
   • Press and hold the or buttons repeatedly to skip tracks.
4. When finished listening, press and hold the "Power Button" approximately 1 second to shut off the unit.

Notes:

• Up to 16 GB TF (Micro SD) Card /USB Device supported.
• When inserting the TF (Micro SD) Card /USB Device, make sure the direction you selected is correct. Never insert violently to avoid damaging the TF (Micro SD) Card /USB Device or the unit. If it doesn't work, please check if the direction is correct.
• Before replacing TF (Micro SD) Card /USB Device, make sure the unit has been powered off.
• You also need to download the desired music in MP3 format into the TF (Micro SD) Card /USB Device before insert into the unit.

TROUBLESHOOTING

Check the following before requesting service:

SYMPTOM	POSSIBLE CAUSE	POSSIBLE SOLUTION
Can't power on	Built-in battery drained	Recharge the battery
	The unit is in power off mode	Press and hold the Button approximately 0.5 second to power on the unit
No sound or sound weak	Volume of the unit was set to minimum position	Increase the volume level by press and release the Button repeatedly
	Volume level of paired/connected device is in low level	Rise the volume level of the paired/connected device
Sound distortion	Volume level too high	Reduce the volume level by press and release the Button repeatedly
	Volume level of the paired/connected device too high	Reduce the volume level of the paired/connected device
BT not functioning	The external BT device had NOT paired to the unit	Pair the external BT Device to the unit
	The external BT device too far from the unit	Place the external BT device close to the unit

SPECIFICATIONS

Power Source	Built-in DC 3.7 V, 1200 mAH (4.44 WH) rechargeable Li-ion Battery; recharge by DC 5 V through DC 5V (Micro USB) Port
Impedance of Speakers	5 W; 3 ohm per channel
Audio Power	3 W per Channel(Total 6 W, RMS)
BT Version	4.1
BT Operation Distance	≦ 32 Feet in open area

PACKAGE INCLUDES

1 x Owner's Manual
1 x USB Connection Cable (For Charging only)
1 x Audio Connection Cable with 3.5 mm Stereo plugs

SPECIFICATIONS AND ACCESSORIES ARE SUBJECT TO CHANGE WITHOUT NOTICE

Documents / Resources

Download manual

Here you can download full pdf version of manual, it may contain additional safety instructions, warranty information, FCC rules, etc.

Download Magnavox MMA3727 - Stereo Portable Speaker with Bluetooth Wireless Technology Manual