FCC NOTICE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
LOCATION OF CONTROLS MAIN UNIT: FRONT VIEW TOP VIEW REAR VIEW 1. VOLUME Knob 4. Power ON/OFF Switch 5. DC 5V Jack (Micro USB 2. Indicators Port, for charging only) 3. Remote Sensor 6. AUX (in) Jack REMOTE CONTROL: (Power On/Off) Button (Previous) Button 3.
BATTERY INSTALLATION FOR REMOTE CONTROL FIRST TIME USE ● Remove and discaed the insulation tab as figure on the right. ● Replacing the button cell of the it when it was drained as follows: 1. Push and slide out the battery holder as figure 1 below. 2.
POWER SOURCE: The unit has a built in Li-ion rechargeable battery, recharge it before use or when it is drained as follows: Connect the Micro USB Plug from the supplied USB Connection Cable to th e DC 5V Jack ( Micro USB Por on the rear of unit.
For energy saving, if unit is not to be used for an extended period of time, turn off the unit by slide the Power ON/OFF Switch to OFF position. When the external BT device searched the unit, our model number “MR4207” will appear on the display of external BT Device.
Page 7
AUX IN: To listen from an external Audio Player such as a MP3 Player, Discman …etc. 1. Connect one end of the supplied Audio Connection Cable to the AUX Out / Line Out / Phone Jack on the external Audio Player. 2.
TROUBLESHOOTING Check the following before requesting service: SYMPTOM POSSIBLE CAUSE POSSIBLE SOLUTION Can’t power on Built in battery drained Recharge the battery as page 5 Rising the volume level by turning the VOLUME Knob on the unit clockwise or No sound or Volume level of the unit is low press the VOL (Volume) + Button on the sound weak...